Hyundai Palisade: Starting System / Description and operation

The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.

When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.

The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.

The contacts close and the starter motor cranks.

In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

Starting System

..

Troubleshooting

Troubleshooting    • The battery must be in good condition and fully charged for this troubleshooting...

Other information:

Hyundai Palisade (LX2) 2020-2024 Service Manual: Troubleshooting

Troubleshooting Symptom Passible Cause Remedy (Refer to page) Water leaks from sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid-to-body clearance and improperly fitted weatherstrip Adjust Wind noise around sunroof Loose or deformed deflector, gaps in body work Retighten adjust or replace Noise created by moving sunroof lid Foreign particles lodged in guide rail Check drive cable and guide rails for foreign particles Loose guide rails and lid Retighten Motor runs but sunroof does not move or moves only partially Foreign particles lodged in guide rail Adjust or replace Incorrect engagement of motor pinion with drive cable Decrease in motor's clutch slipping force Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc...

Hyundai Palisade (LX2) 2020-2024 Service Manual: Rear Corner Safety ON/OFF Switch

Components and components location Circuit Diagram Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crashpad Lower Panel") 3...