Hyundai Palisade: Automatic Transaxle Cooling System / Description and operation
• |
Engine coolant is used for circulating heat in order to heat and cool
the transaxle oil.
|
• |
Prevents over heating of the transaxle oil while the vehicle is moving.
Flow of the coolant

|
Repair procedures
Removal
•
ATF cooler is a unit with the radiator, so refer to radiator
removal / installation procedures in the engine section...
Other information:
Components and components location
Component
Connector Pin Function
Connector
PIN No
Pin Function
Connector
PIN No
Pin Function
A
1
Battery
A
21
IGN2
2
ISG B+
22
IGN1
3
ILL+ (TAIL)
23
Blower Motor (+)
4
Sensor Ground REF (+5V)
24
Photo Sensor (-)_LEFT
5
Mode Control Actuator Feedback
25
Photo Sensor (-)_RIGHT
6
Temperature Actuator Feedback - Driver
26
Incar Sensor (+)
7
Intake Actuator Feedback
27
Incar Motor (-)
8
Evaporator Temperature Sensor (+)
28
PTC Relay 3
9
Ambient Temperature Sensor (+)
29
PTC Relay 3
10
Mode Control Actuator (Vent)
30
PTC On Signal
11
Mode Control Actuator (Defrost)
31
Detent out (-)
12
Temperature Control Actuator (Cool) - Driver
32
K - Line
13
Temperature Control Actuator (Warm) - Driver
33
P_CAN High
14
Intake Actuator (Fresh Air)
34
P_CAN Low
15
Intake Actuator (Recirculated Air)
35
Mosfet (DRAIN F/B)
16
HTD (Rear Defrost)
36
Mosfet (GATE)
17
Rear Defogging Swich
37
ECV +
18
Clean Signal
38
ECV -
19
Ionizer Diagnosis
39
Sensor Ground
20
ILL - (RHEO)
40
Ground
Connector
PIN No
Pin Function
Connector
PIN No
Pin Function
B
1
Temperature Control Actuator Feedback - Passenger
B
9
-
2
Temperature Control Actuator (Cool) - Passenger
10
-
3
Temperature Control Actuator (Warm) - Passenger
11
-
4
Defogging Actuator Feedback
12
Defogging Sensor TEMP
5
Defogging Actuator (Open)
13
Defogging Sensor SCK
6
Defogging Actuator (Close)
14
Defogging Sensor Data
7
-
15
-
8
Seat Signal PWM - Driver
16
Ground
Repair procedures
Self Diagnosis
1...
Repair procedures
Oil Specification
1.
The R-134a or R-1234yf system requires synthetic (PAG) compressor oil
whereas the R-12 system requires mineral compressor oil. The two oils
must never be mixed.
2...
Categories

To lock your vehicle using the door
handle button or the Smart Key:
1.Make sure all doors, the hood and
the liftgate are closed.
2.Make sure you have the smart key
in your possession.
read more