Hyundai Palisade: Front Door / Front Door Side Weatherstrip

Hyundai Palisade (LX2) 2020-2025 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Side Weatherstrip

Repair procedures

Replacement

[Front door side weatherstrip]

Loosen the front door checker (B) mounting bolt.

Tightening torque :

21.6 - 32.4 N.m (2.2 - 3.3 kgf.m,15.9 - 23.9 lb-ft)

2.	Detach the clips, then remove the front door side weatherstrip (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

[Front door body side weatherstrip]

4.	Detach the clips, then remove the front door body side weatherstrip (A).

5.	To install, reverse removal procedure.

Front Door Belt Inside Weatherstrip

Repair procedures Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2...

Rear Door

Other information:

Hyundai Palisade (LX2) 2020-2025 Service Manual: Heater & A/C Control Unit (Rear)

Components and components location Component Connector Pin Function Connector PIN No Pin Function Connector PIN No Pin Function A 1 Battery A 17 IGN2 2 ISG B+ 18 IGN1 3 ILL+ (TAIL) 19 Blower Motor (+) 4 Sensor Ground REF (+5V) 20 - 5 Mode Control Actuator Feedback 21 Mosfet (DRAIN F/B) 6 Temperature Actuator Feedback 22 Mosfet (GATE) 7 Mode Control Actuator (Vent) 23 Heater Switch _ LH 8 Mode Control Actuator (Defrost) 24 Indicator (HIGH) _ LH 9 Temperature Control Actuator (Cool) 25 Indicator (MID) _ LH 10 Temperature Control Actuator (Warm) 26 Indicator (LOW) _ LH 11 Detent out (-) 27 Heater Switch _ RH 12 K - Line 28 Indicator (HIGH) _ RH 13 LIN Left 29 Indicator (MID) _ RH 14 Lin Right 30 Indicator (LOW) _ RH 15 - 31 Sensor Ground 16 ILL - (RHEO) 32 Ground Repair procedures Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Hyundai Palisade (LX2) 2020-2025 Owner's Manual: Immobilizer Indicator Light

Immobilizer Indicator Light (without smart key) This indicator light illuminates: • When the vehicle detects the immobilizer in the key with the ignition switch in the ON position. - At this time, you can start the engine. - The indicator light goes off after starting the engine...