Hyundai Palisade: Driver position memory system / Resetting the Driver's Seat
Memory System
Take the following procedures to reset
the driver's seat memory system,
when it does not operate properly.
To reset the driver's seat memory
system
1. Place the ignition switch to the ON
position, shift to P (Park), and
open the driver's door.
2. Operate the control switch to set
the driver's seat and seatback to
the foremost position.
3. Simultaneously press the SET
button and push forward the seat
movement switch over 2 seconds.
While resetting the driver's seat
memory system
1. It starts with the notification sound.
2. The driver's seat and seatback is
adjusted to the rearward position
with the notification sound.
3. The driver's seat and seatback is
re-adjusted to the default position
(central position) with the notification
sound.
However, in the following cases, the
resetting procedure and the notification
sound may stop.
- The memory button is pressed.
- The control switch is operated.
- The driving speed exceeds 2 mph
(3 km/h).
- The driver's door is closed.
CAUTION
- If the reset is failed, initialize
the system once again.
- Initialize the system after
cleaning the obstacles surrounding
of seat.
- After completing the initialization,
adjust the driver position
memory system again.
NOTICE
- Reattempt to do the resetting
procedure again, when the
resetting procedure incompletely
stops or the notification
sound do not stop.
- Make sure that there is no obstacle
around the driver's seat in
advance of resetting the driver's
seat memory system.
Storing Positions into Memory
1. Shift to P (Park) position.
2. Adjust the driver's seat position,
side view mirror position, instrument
panel illumination intensity
and head-up display height/brightness
to positions comfortable for
the driver...
The system will move the driver's
seat automatically as follows:
With remote key
- It will move the driver's seat rearward
and downward when the ignition
key is removed...
Other information:
If your vehicle is equipped with a
sunroof, you can slide or tilt your
sunroof with the sunroof control lever
located on the overhead console.
The ignition switch must be in the ON
position before you can open or close
the sunroof.
The sunroof can be operated for
approximately 10 minutes after the
ignition switch is removed or turned
to the ACC or LOCK/OFF position...
Components and components location
Components
Connector Pin Information
No
Connector A
Connector B
1
Battery (+)
Rear left door speaker (+)
2
Battery (+)
Rear left door speaker (-)
3
Battery (+)
Rear right door speaker (+)
4
Battery (+)
Rear right door speaker (-)
5
-
-
6
M-CAN (High)
-
7
M-CAN (Low)
-
8
ACC
-
9
Navigation voice (+)
-
10
-
-
11
-
-
12
Front left door speaker (+)
-
13
Front left door speaker (-)
Surround left speaker (+)
14
Front right door speaker (+)
Surround left speaker (-)
15
Front right door speaker (-)
Surround right speaker (+)
16
Ground
Surround right speaker (-)
17
Ground
Sub woofer speaker1 (+)
18
Ground
Sub woofer speaker1 (-)
19
Ground
Sub woofer speaker2 (+)
20
SPDIF (+)
Sub woofer speaker2 (-)
21
SPDIF (-)
-
22
SPDIF ground
-
23
Navigation voice (-)
-
24
IGN 1
25
Front left tweeter speaker (+)
-
26
Front left tweeter speaker (-)
-
27
Front right tweeter speaker (+)
Center speaker (+)
28
Front right tweeter speaker (-)
Center speake (-)
Repair procedures
Removal
External Amplifier
1...