Hyundai Palisade: Sunroof / Resetting the rear sunshade

Hyundai Palisade (LX2) 2020-2025 Owner's Manual / Convenient Features of Your Vehicle / Sunroof / Resetting the rear sunshade

The rear sunshade may need to be reset if the following conditions occur:

- Battery is discharged or disconnected or the related fuse has been replaced or disconnected
- The rear sunshade does not normally operate

To reset the rear sunshade, perform the following steps:

1. Turn the engine on.

2. Push the rear sunshade CLOSE button. The rear sunshade will close completely.

3. Push the rear sunshade CLOSE button about 10 seconds.

The rear sunshade will slightly move.

Do not release the CLOSE button until the operation is completed.

If you release the CLOSE button, try again from step 2.

4. Within 3 seconds, push the CLOSE button until the rear sunshade operates as follows :

Open → Close

Do not release the CLOSE button until the operation is completed.

If you release the CLOSE button during operation, try again from step 2.

5. Release the CLOSE button after all operation has completed.

The rear sunshade system has been reset.

Resetting the Sunroof

■ Front ■ Rear The sunroof may need to be reset if the following conditions occur: The battery is discharged or disconnected or the sunroof fuse has been replaced or disconnected The sunroof control lever is not operating correctly To reset the sunroof, perform the following steps: 1...

Sunroof Open Warning

■ Type A ■ Type B If the driver turns off the engine when the sunroof is not fully closed, the warning chime will sound for approximately 3 seconds and the sunroof open warning will appear on the cluster LCD display...

Other information:

Hyundai Palisade (LX2) 2020-2025 Service Manual: Components and components location

Component Location (1) 1. Integrated Body Control Unit (IBU) 2. Buzzer 3. Door outside handle 4. Interior antenna 2 5. Interior antenna 1 Component Location (2) 1. Bumper antenna 2...

Hyundai Palisade (LX2) 2020-2025 Service Manual: General Service Information

General information General Service Information Protection of the Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. • The support rod must be inserted into the hole near the edge of the hood whenever you inspect the engine compartment to prevent the hood from falling and causing possible injury...