Hyundai Palisade: SRSCM / Side Impact Sensor (SIS)
Components and components location

1. Gravity Side Impact Sensor
[G-SIS (B-Pillar)]
2. Gravity Side Impact Sensor [G-SIS (C-Pillar)]
|
3. Front Pressure Side Impact
Sensor (P-SIS)
|
Description and operation
The Side Impact Sensor (SIS) system consists of two kinds of side impact sensor
which are installed at each center of the front door module (left and right)
and two rear sensors which are installed in the rear pillar (left and right).
• |
The Front Side Impact Sensor is also called P-SIS because it detects
pressure due to collision at its mounting location.
|
• |
The Rear Side Impact Sensor is also called A-SIS because it detects
acceleration due to collision at its mounting location.
|
SRSCM decides deployment of the airbag and the time of deployment through the
collision signal of the SIS when collision occurrs.
Components and components location
Components
1. Front impact sensor (FIS)
2. Front impact sensor (FIS)
Description and operation
Description
The front impact sensor (FIS) is installed in the Front End Module (FEM)...
Other information:
Description
–
FCA system is designed to help avoid a potential collision or reduce
its impact when drivers applies inadequate, delayed or no brakes at
all to avoid a collision.
–
The system detects the risk factors on the road by using the frontal
impact sensor and warn the driver and activate the emergency brake to
prevent collision or reduce collision speed...
1. The Safe Exit Assist system is provided
to help prevent the passengers
from opening a door by warning
the passengers when an approaching
vehicle from the rear area is
detected after the vehicle stops.
2. When an approaching vehicle
from the rear area is detected
after the vehicle stops, the rear
door does not unlock even when
the driver tries to unlock the rear
door using the Electronic child
safety lock button...
Categories
Seat belt warning light

Driver's seat belt warning
As a reminder to the driver, the seat
belt warning light will illuminate for
approximately 6 seconds each time
you place the ignition switch to the
ON position regardless of belt fastening.
At this time, if the seat belt is
not fastened a warning chime will
sound for 6 seconds.
read more