Hyundai Palisade: Restraint / Special service tools
Tool(Number and Name)
|
Illustration
|
Use
|
Deployment tool
0957A-34100A
|
|
Airbag deployment tool.
Use with (0957A-AL140, 0957A-AL160)
|
Dummy
0957A-38200
|
|
Simulator to check the resistanceof each wiring harness.
Use with (0957A-AL170, 0957A-AL190)
|
Airbag deployment & dummy adapter kit
0957A-AL100
|
|
Use with airbag deployment and airbag inspection.
|
Deployment adapter
0957A-AL140
|
|
Use with deployment tool.
(0957A-34100A) (DAB, PAB, CAB, BPT)
|
Deployment adapter
0957A-AL160
|
|
Use with deployment tool.
(0957A-34100A) (SAB)
|
Dummy adapter
0957A-AL170
|
|
Use with dummy.
(0957A-38200) (DAB, PAB, CAB, BPT)
|
Dummy adapter
0957A-AL190
|
|
Use with dummy.
(0957A-38200) (SAB)
|
DAB : Driver Airbag
PAB : Passenger Airbag
SAB : Side Airbag
CAB : Curtain Airbag
BPT : Seat Belt Pretensioner
Tightening Torques
Item
N.m
kgf.m
lb-ft
Passenger Air Bag
8...
Precautions
General Precautions
Please read the following precautions carefully before performing the airbag
system service...
Other information:
Troubleshooting
Symptom
Probable cause
Remedy
Play in steering
Loose yoke plug
Retighten
Loose steering gear mounting bolts
Retighten
Loose or worn tie rod end
Retighten or replace as necessary
Steering wheel operation is not smooth (Insufficient power assist)
V-belt slippage
Readjust
Damaged V-belt
Replace
Low fluid level
Replenish
Air in the fluid
Bleed air
Twisted or damaged hoses
Correct the routing or replace
Insufficient oil pump pressure
Repair or replace the oil pump
Sticky flow control valve
Replace
Excessive internal oil pump leakage
Replace the damaged parts
Excessive oil leaks from rack and pinion in gear box
Replace the damaged parts
Distorted or damaged gear box or valve body seals
Replace
Steering wheel does not return properly
Excessive turning resistance of tie rod end
Replace
Yoke plug excessively tight
Adjust
Tie rod and/or ball joint cannot turn smoothly
Replace
Loose mounting of gear box mounting bracket Worn steering shaft joint and/or
Retighten
Worn steering shaft joint and / or body grommet
Correct or replace
Distorted rack
Replace
Damaged pinion bearing
Replace
Twisted or damaged hoses
Reposition or replace
Damaged oil pressure control valve
Replace
Damaged oil pump input shaft bearing
Replace
Noise
Hissing Noise in Steering Gear
There is some noise with all power steering systems...
Repair procedures
Replacement
1.
Using a clip remover, remove the clips and then the hood insulator pad
(A).
•
Be careful not to scratch the hood panel...
Categories
The SRS consists of the following
components:
1. Driver's front air bag module
2. Passenger's front air bag module
3. Side air bag modules
4. Curtain air bag modules
5. Retractor pre-tensioner
6. Air bag warning light
7. SRS control module (SRSCM)/
Rollover sensor
8. Front impact sensors
9. Side impact sensors
10.Side pressure sensors
11. Occupant classification system
12. Driver’s knee airbag module
read more