Hyundai Palisade: Air Bag - Advanced Supplemental Restraint
System / SRS Care
The SRS is virtually maintenancefree
and there are no parts you can
safely service by yourself. If the SRS
air bag warning light does not illuminate
when the ignition switch is in the
ON position, or continuously remains
on, have your vehicle immediately
inspected by an authorized HYUNDAI
dealer.
Any work on the SRS system, such
as removing, installing, repairing, or
any work on the steering wheel, the
front passenger's panel, front seats
and roof rails must be performed by
an authorized HYUNDAI dealer.
Improper handling of the SRS system
may result in serious personal injury.
WARNING
To reduce the risk of serious
injury or death, take the following
precautions:
- Do not attempt to modify or
disconnect the SRS components
or wiring, including the
addition of any kind of badges
to the pad covers or modifications
to the body structure.
- Do not place objects over or
near the air bag modules on
the steering wheel, instrument
panel, or the front passenger’s
panel above the glove
box.
- Clean the air bag pad covers
with a soft cloth moistened
with plain water. Solvents or
cleaners could adversely
affect the air bag covers and
proper deployment of the system.
- Always have inflated air bags
replaced by an authorized
HYUNDAI dealer.
- If components of the air bag
system must be discarded, or if
the vehicle must be scrapped,
certain safety precautions
must be observed. Consult an
authorized HYUNDAI dealer for
the necessary information.
Failure to follow these precautions
could increase the risk of
personal injury.
Front air bags
Front air bags and the driver's knee
air bag are designed to inflate in a
frontal collision depending on the the
severity of impact of the front collision...
Passengers should not move out
of or change seats while the vehicle
is moving. A passenger who is
not wearing a seat belt during a
crash or emergency stop can be
thrown against the inside of the vehicle,
against other occupants, or be
ejected from the vehicle...
Other information:
The remote key will not work if any of
the following occur:
The key is in the ignition switch.
You exceed the operating distance
limit (about 90 feet [30 m]).
The remote key battery is weak.
Other vehicles or objects may be
blocking the signal...
Components and components location
Components
IMS input/output pin information
No
Connector A
Connector B
Connector C
1
Cushion extension moter (Front)
B+ (Power)
Seat slide motor switch (Front)
2
Seat recline motor (Front)
Ground (Power)
Seat recline switch (Front)
3
Seat height motor (Up)
B+ (Power)
Seat tilt switch (Up)
4
Seat slide motor(Front)
-
Seat height switch (Up)
5
Seat Cushion extension moter (Rear)
Ground
Seat cushion extension switch (Front)
6
Seat recline motor (Rear)
B_CAN (High)
7
Seat tilt motor (Up)
B_CAN (Low)
8
Seat tilt motor (Down)
Lumber motor (Up)
9
Seat height motor (Down)
Lumber motor (Down)
10
Seat slide motor (Rear)
Seat slide sensor
11
Seat tilt sensor
12
-
13
Seat position sensor power
14
IGN 1
15
Seat slide switch (Rear)
16
Seat recline switch (Rear)
17
Seat tilt switch (Down)
18
Seat height switch (Down)
19
Seat cushion extension switch (Rear)
20
Ground
21
Lumber motor (Low)
22
IMS switch 2
23
-
24
Seat recline sensor
25
Seat height sensor
26
-
27
-
28
Battery (+)
Repair procedures
Removal
1...
Categories
To lock your vehicle using the door
handle button or the Smart Key:
1.Make sure all doors, the hood and
the liftgate are closed.
2.Make sure you have the smart key
in your possession.
read more