Hyundai Palisade: Exterior Lights / Turn signals and lane change
signals

To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A).
If an indicator stays on and does not
flash or if it flashes abnormally, one of
the turn signal bulbs may be burned
out and will require replacement.
One-touch turn signal function
To activate the One Touch Turn
Signal function, push the turn signal
lever up or down to position (B) and
then release it.
The lane change signals will blink 3,
5 or 7 times.
You can activate or deactivate the
One Touch Turn Signal function or
choose the number of blinks (3, 5, or
7) from the User Settings mode in
the LCD display.
The High Beam Assist (HBA) is a
system that automatically adjusts the
headlamp range (switches between
high beam and low beam) according
to the brightness of other vehicles
and road conditions...
Battery saver function
The purpose of this feature is to help
prevent the battery from being discharged.
The system automatically
turns off the parking lamp when the
driver turns the vehicle off and opens
the driver-side door...
Other information:
Components and components location
Component Location
1. Front center fascia panel
2. Rear center fascia panel
Repair procedures
Replacement
[Front center facsia panel]
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque :
107...
Categories
Rear seat adjustment

Forward and rearward
(2nd row seat)
To move the seat forward or rearward:
1. Pull the seat slide adjustment
lever up and hold it.
2. Slide the seat to the position you
desire.
read more