Hyundai Palisade: Body (Interior and Exterior) / Fender
Troubleshooting
Symptom
Passible Cause
Remedy (Refer to page)
Water leaks from sunroof
Deteriorated roof lid weatherstrip
Replace
Excessive roof lid-to-body clearance and improperly fitted weatherstrip
Adjust
Wind noise around sunroof
Loose or deformed deflector, gaps in body work
Retighten adjust or replace
Noise created by moving sunroof lid
Foreign particles lodged in guide rail
Check drive cable and guide rails for foreign particles
Loose guide rails and lid
Retighten
Motor runs but sunroof does not move or moves only partially
Foreign particles lodged in guide rail
Adjust or replace
Incorrect engagement of motor pinion with drive cable
Decrease in motor's clutch slipping force
Increased sunroof sliding resistance or interference of sunroof with drive
cables, weatherstrip, etc...
Other information:
To use the side curtain:
1. Lift the curtain by the curtain knob
(1).
2. Hang the curtain on both sides of
the hook.
CAUTION
Always hang both sides of the
curtain on the hook. This
could cause damage to the
side curtain if only one side of
the curtain is hooked...
Components and components location
Components
1. Gravity Side Impact Sensor
[G-SIS (B-Pillar)]
2. Gravity Side Impact Sensor [G-SIS (C-Pillar)]
3. Front Pressure Side Impact
Sensor (P-SIS)
Description and operation
Description
The Side Impact Sensor (SIS) system consists of two kinds of side impact sensor
which are installed at each center of the front door module (left and right)
and two rear sensors which are installed in the rear pillar (left and right)...
Categories
The SRS consists of the following
components:
1. Driver's front air bag module
2. Passenger's front air bag module
3. Side air bag modules
4. Curtain air bag modules
5. Retractor pre-tensioner
6. Air bag warning light
7. SRS control module (SRSCM)/
Rollover sensor
8. Front impact sensors
9. Side impact sensors
10.Side pressure sensors
11. Occupant classification system
12. Driver’s knee airbag module
read more