Hyundai Palisade: Electronic Parking Brake
(EPB) / Parking brake warning light
Check the Parking
Brake Warning Light
by placing the ignition
switch to the ON position
(do not start the
engine).
This light will be illuminated when the
parking brake is applied with the ignition
switch in the START or ON position.
Before driving, be sure the parking
brake is released and the Brake
Warning Light is OFF.
If the Parking Brake Warning Light
remains on after the parking brake is
released while engine is running,
there may be a malfunction in the
brake system. Immediate attention is
necessary.
If at all possible, cease driving the
vehicle immediately. If that is not possible,
use extreme caution while
operating the vehicle and only continue
to drive the vehicle until you
can reach a safe location.
This warning light illuminates if the
ignition switch is set to the ON position
and goes off in approximately 3
seconds if the system is operating
normally...
If there is a problem with the brake
pedal while driving, emergency braking
is possible by pulling up and
holding the EPB switch. Braking is
possible only while you are holding
the EPB switch...
Other information:
Special Service Tools
Tool (Number and name)
Illustration
Use
Crankshaft front oil seal installer
(09231-3C100)
Installation of the front oil seal
Ring gear stopper
A : 09231-3N100
B : 09231-2B100
Removal and installation of crankshaft pulley bolt
Ring gear stopper
A : 09231-3D100
B : 09231-2W100
Removal and installation of crankshaft pulley bolt...
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp lens from the panel after loosening a screw.
3.
Replace the bulb (B) after removing the license lamp (A)...
Categories
1. Driver's front air bag
2. Passenger's front air bag
3. Side air bag
4. Curtain air bag
5. Driver’s knee airbag
This vehicle is equipped with an
Advanced Supplemental Air Bag
System for the driver's seat and front
passenger's seats.
read more