Hyundai Palisade: Rear Corner Radar System / Rear Corner Safety ON/OFF Switch

Hyundai Palisade (LX2) 2020-2025 Service Manual / Advanced Driver Assistance System (ADAS) / Rear Corner Radar System / Rear Corner Safety ON/OFF Switch

Components and components location

Circuit Diagram

Hyundai Palisade. Components and components location

Repair procedures

Inspection

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to Body - "Crashpad Lower Panel")

3.	Remove the side air vent duct (LH).

4.	Remove the lower crash pad switch assembly after loosening the screws.

5.	Remove the rheostat switch connector.

6.	Check for intensity of new rheostat switch. If the light intensity of the lamps changes smoothly without any flickering when the rheostat is turned, it can be assumed that the rheostat is normal.

Rear Corner Radar Unit

Specifications Specifications [BCW, BCA] Items Blind-Spot Collision Warning (BCW) Blind-Spot Collision- Avoidance Assist (BCA) Rated voltage DC 12V Operating voltage 9V - 16V Operating speed 30 km/h - 255 km/h 60 km/h - 180 km/h Sensible distance 70m Curvature radius Start : More than 100m Start : More than 625m Stop : Less than 70m Stop : Less than 588m Frequency 76 - 77 GHz Numbers 2EA [RCCW, RCCA] Items Rear Cross-Traffic Collision Warning System (RCCW) Rear Cross-Traffic Collision- Avoidance Assist (RCCA) Rated voltage DC 12V Operating voltage 9V ~ 16V Operating speed 0 km/h ~ 10 km/h 0...

Warning Indicator

Components and components location Components 1. Warning indicator 2. SVM camera Repair procedures Removal 1...

Other information:

Hyundai Palisade (LX2) 2020-2025 Owner's Manual: Normal Maintenance Schedule (3.8 GDI)

I : Inspect and if necessary, adjust, correct, clean or replace. R : Replace or change. *1 : The drive belt should be replaced when cracks occur or tension is reduced. *2 : If TOP TIER Detergent Gasoline is not available, one bottle of additive is recommended...

Hyundai Palisade (LX2) 2020-2025 Service Manual: Ultrasonic Sensor

Schematic diagrams Schematic Diagrams Repair procedures Removal 1. Remove the bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 2...