Hyundai Palisade: Automatic Transaxle System (A8LF1) / Automatic Transaxle Control System
Hyundai Palisade (LX2) 2020-2025 Service Manual / Automatic Transaxle System (A8LF1) / Automatic Transaxle Control System
- Description and operation
- Repair procedures
- Transaxle Control Module (TCM)
- Electronic Shift Actuator
- Oil Temperature Sensor (Main Harness)
- Speed Sensor
- Position Sensor
- Electric Shift Button
- SBW Control Unit (SCU)
Oil Cooler
Repair procedures
Removal
•
ATF cooler is a unit with the radiator, so refer to radiator
removal / installation procedures in the engine section...
Description and operation
Description
•
Automatic transaxle system relies on various measurement data to determine
the current control status and extrapolate the necessary compensation
values...
Other information:
Hyundai Palisade (LX2) 2020-2025 Service Manual: Rear Coil Spring
Repair procedures Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque : 107...
Hyundai Palisade (LX2) 2020-2025 Owner's Manual: Walk-in seat (2nd row seat)
To get in or out of the 3rd row seat, 1. Routing the seat belt webbing through the rear seat belt guide clip. After inserting the seat belt, tighten the belt webbing by pulling it up. 2. Push the walk-in switch located on top (1) of the 2nd row seat or the side (2) of the seat bottom cushion...
Categories
- Manuals Home
- 1st Generation Palisade Owners Manual
- 1st Generation Palisade Service Manual
- Emergency liftgate safety release
- Child-Protector Rear Door Locks
- Auto Hold
- New on site
- Most important about car
Rear Seats
Rear seat adjustment
Forward and rearward (2nd row seat)
To move the seat forward or rearward:
1. Pull the seat slide adjustment lever up and hold it.
2. Slide the seat to the position you desire.
Copyright © 2025 www.hpalisadelx.com